HOME / PROJECT SCOPE / FINAL DESIGN / DATA AND RESULTS / CONCLUSION / TEAM
FLORIDA STATE UNIVERSITY / FAMU-FSU
COLLEGE OF ENGINEERING
ASSEMBLY
This is a cap that goes on the top or bottom of the
heat exchanger.
Below is the bottom portion of the heat exchanger
with the bottom cap attached.
Below
is the Six Intake pipes with the manifold attached to hold them in place once
inside the
heat
exchanger.
This is the intake pipes and manifold inside the
bottom shell with the bottom cap attached.
This is everything assembled except for the top cap.
View of
the inside of the top of the outer shell. The inside shells and manifold can be
seen.
View into
the exhaust intake and exit of the exhaust along with the intake piping.
Full
assembly.
Heater of
the dryer. An attachment was fabricated to accept a round tube to
route the pre-heated air into it.
Connected
to the dryer.
Another
assembly picture.
FAMU-FSU