FINAL DESIGN

Meet our sponsor: Talla-Tech

Project Description
 

Final Design

   * Sub-systems

      - base/rack

        - set-up platform

        - wedges/support platform

        - lock/release mechanism

        - computer interface

   * Forces and Stresses

   * Cost analysis

   * Complete assembly

Problems and Solutions
 

Pictures and Videos

Team 11

 

BASE AND RACK

The base and the rack constitute the main support structure for all the other components.

* BASE

The base is made out of three sections of 4" x 4" x 1/4" steel tubes. The sections are welded together as well as two L shaped brackets that are used to hold the rack in position. In addition, the base rests on 4 wheels that facilitate transportation, and they can be locked in position whenever a test is being performed to avoid any sliding.

* RACK

The rack is made out of aluminum and attached to the brackets on the base by 4 bolts. It has 1/2" holes along its frontal side spaced out every 2 inches. The rack was purchased with the holes to avoid the need to machine them, reducing the manufacturing time. The sleeves will slide up and down the rack and can be locked using a pin when the desired height is achieved.